1. Before using Panic Button please fully charge it. In order to charge put on the QI
Wireless charger and ensure that Red Led is On. It may flash during the charge.
Confirmation that is fully charged when LED turns green.
2.
Quick press will activate Alarm mode. Red Led starting to flash and internal Buzzer is On.
Button in few seconds will be connected to the Wi-Fi and will deliver Alarm to the EMS
Server, and next will start to scan Positioning points. Every 7 seconds is sending list of
points to the EMS server, in order to calculate his location.
3.
EMS is popping-up Alarm on the Live Panel and updating Panic Button Location. Keep in
mind that button works in supervision mode, and if Wi-Fi signal is lost or weak, it will
continue to send until will not receive confirmation from server. It is important to have
strong Wi-Fi signal, if not the battery will drain quick.
4.
In order to Cancel Alarm, is required to Hold the Button longer than 6 seconds. The LED
will turn Off and Buzzer deactivated.
5.
If the Panic Button need to be programmed again, i.e., Wi-Fi new settings, Name, ID etc.
then to activate programming mode do the following:
a. Enable Alarm Mode, LED and buzzer must be activated
b. Press 25 times the button until the buzzer will shut off
c. Now the button works in Access point mode
d. Go to your laptop or PC with the Wi-Fi enabled
e. Search for the vantact-xxxxxxxxx SSID and connect to it, it is open
f. In the browser type 192.168.168.1, no user and password prompt
g. In the provided page go through the settings, change all as required
h. Go to the save menu, and click on the page on the Save button
i.
Button will reboot and go to the deep sleep mode.
When Programming mode is activated, Panic
Button goes to the Access Point Mode, and using
any Wi-Fi enabled device, i.e., Laptop, Tablet or
Smart Phone you can connect directly to the web
interface of the Panic Button.
Please keep the Panic Button always charged, do not allow to be fully discharged as the battery
used is standard Li-Io battery type, and if discharged may leak and destroy internal
components. Internal charger has overcharge protection, so is safe to keep it on the QI charge
overnight, full time etc. and use the button when is required.
